Bullet Tools 520 Bedienerhandbuch PDF herunterladen (Seite 7)

Honing the Blade

MAINTENANCE

Hone every 100 cuts

Greasing / Lubricating

After every 100 cuts, lubricate the wear points of the

pins and the bearings as shown. Use a light oil (i.e. 10W

motor oil). This will prevent the machine from wearing

out prematurely. Apply grease (wheel bearing grease)

frequently to the bearings where indicated.

Oil

Grease

Your RCT Shear cuts a wide variety of products.

Please refer to this cut guide for

recommended products and thicknesses.

Please note: Approved materials may vary in density and

hardness. If extreme pressure is required to cut a product,

it may result in damage to your machine. Please contact

Bullet Tools before proceeding. Warranty is void if an

unapproved product damages the machine.

RCT CUT GUIDE

520 Maximum Thickness = 15mm or 5/8”

526 Maximum Thickness = 25mm or 1”

Material

Do NOT Use on

High Pressure Laminate

or Solid Wood!

Replacement Blade for RCT520 is part #520B

Replacement Blade for RCT526 is part #526B

Carpet Tile

Commercial Vinyl Tile

Luxury Vinyl Tile

Parquet

PVC Tile

Rubber Cove Base

Rubber Tile

Soft Plastic

Garage Tile

Push the handle down until blade is 1/4” (6mm) open.

Lay the hone stone against the at face of the blade

(side toward the table). Slide from end to end 2 or 3

times.

1 2 3 4 5 6 7 8

Keine Kommentare

Bullet Tools 520 Bedienerhandbuch Seite 7